User Guide

setting up your new washing machine _15

01 SETTING UP

STEP 2

Removing the shipping bolts

Before using your washer, you must remove the four

shipping bolts from the back of the unit.

1. Loosen all the bolts with the supplied wrench.

2. Slide the bolt and spacer up and remove the bolt with

the spacer through the hole in the rear wall of your

washer. Repeat for each bolt.

3. Fill the holes with the supplied bolt hole covers.

4. Keep the shipping bolts and spacers for future use.

STEP 3

Installing your washer

Place the drain hose in the drain facility.

Be sure an airtight connection is NOT

made between the drain hose and the

standpipe.

The standpipe must be at least 18in.(46

cm) high.

Caution must always be exercised to

avoid collapsing or damaging the drain

hose. For best results, the drain hose

should not be restricted in any way – by

elbows, couplings, or excessive lengths.

For situations where the drain hose

cannot be conveniently elevated to at

least 18in.(46 cm), the drain hose must

be supported.

2. Before connect the inlet hoses to water faucets, check to

ensure a washer is inside coupling.

96” Max

18” Min

96” Max

18” Min

Hose

retainer

Tie

strap

Laundry tub Stand pipe

Hose

Guide

Rubber

Washer

Coupling

WF350AN-02833A_EN.indd 15 2010-02-11 ¿ÀÀü 11:42:12