Washer User's Manual

16_ installing your washer

STEP 2

Connecting the water and the drain

Connecting the water supply hose

To avoid leaks, make sure that your water supply hoses

have rubber seals at both ends. Please make sure to use

new water supply hoses to connect to the water faucets.

Do not reuse old hoses. Only use new hoses when you

install the washing machine. Old hoses could leak or burst

causing ﬂ ooding and property damage.

When you initially install the washer, be sure to use a new

hose. Failing to do so may result in a water leakage or

overﬂ ow and may damage your property.

Do not connect multiple water supply hoses. This may

result in a water leakage and electric shock due to the

water leakage. If the hose is too short, replace the hose

with a longer, high pressure hose.

1. Connect the ends of the water supply hoses to the HOT and COLD faucets.

2. Tighten the ﬁ tting by hand until it is snug, then make two-thirds of a turn

with a wrench.

When you fasten the ﬁ tting, do not fasten it excessively or apply tape

or sealant to the faucet or water supply intake. This may damage the

ﬁ tting.

After you have connected the water supply hose to the faucet,

ensure that it is connected correctly by pulling the water supply hose

downwards.

3. Prepare a bucket for the water that will be emitted when you open

the faucets connected to the two water supply hoses to remove any

foreign substances from them.

4. Connect the ends of the water supply hoses to the water supply

intake connections at the back of the washer.

The water supply hose connected to the HOT faucet must be

connected to the hot water supply intake and the water hose

connected to the COLD faucet must be connected to the COLD

water supply intake.

installing your washer

Rubber Seals

Hose-Connector

Cold Hot

CAUTION

WA484DSHA-03050D_EN.indd Sec3:16WA484DSHA-03050D_EN.indd Sec3:16 2012-07-02  3:39:202012-07-02  3:39:20