Mopping Robot User manual VR20T6001M* Series • Before operating this unit, please read the instructions carefully. • For indoor use only VR6000TM_UM_Mopping-Robot_NA_EN.
User manual Please read this manual carefully before operating Mopping Robot. Note that this manual also includes the Warranty Card, so please store in a convenient location for future use. Mopping Robot is not designed for Industrial or Commercial use. Please fully charge the battery before first use.
Safety information The following content provides important information in using Mopping Robot correctly, and preventing damage or danger to user. Samsung assumes no responsibility for technical or editorial errors or omissions contained herein, nor for any incidental or consequential damages and failures of appliance caused by not following the precautions and instructions. Warning • Do not use power cord if it is damaged.
• Remove and allow mop pads to dry after use. Do not leave wet mops on floors for an extended period of time, as you risk damaging your floors. • Make sure that children or pets do not step or sit on the robot cleaner while operating. • Mopping Robot is designed for indoor usage. • Power off Mopping Robot whenever you are switching cleaning pads or adding water to the mop kits. • Make sure the sensor windows are clean and obstruction free prior to use.
Parts name & Product component Components Main unit Floor plate Water supply mop kit Mother yarn mop (Gray color) Microfiber mop (Green color) Remote control (with battery) Power adapter Silicone brush Note Mother yarn mop (Gray color) Mother yarn is 100x thicker than microfiber, ideal for cleaning dust in cracks and picking up spills. Microfiber mop (Green color) It is a mop with richer and longer yarns for a superior wiping performance. English 5 VR6000TM_UM_Mopping-Robot_NA_EN.
Main unit / Front Illumination sensor/Remote control receiver Handle Operation button/ LED lamp Obstacle detection sensor Cliff detection sensor Main unit / Bottom Main unit / Rear Power jack Mop guide kit Water supply mop kit / Top Water supply mop kit / Bottom Mop velcro Rubber cap Water inlet Water supply wick 6 English VR6000TM_UM_Mopping-Robot_NA_EN.
Charging status & Indication Caution • Only use authorized adapter. Or, it may cause serious damage to the product. • Do not charge the non-rechargeable batteries. How to charge Connect the power adapter to the charging port on the back of main unit. Remove the protective film from the product before use. Battery level indication Battery level can be checked through LED lamp.
Installing the water supply mop kit Caution • Please disconnect and power off the Mopping Robot when you install or detach the water supply mop kits. • Please wring the water out of the mops prior to use, otherwise the cleaning process may slow down. • Make sure to fill the water supply mop kit before use. Using the product without water in the water supply mop kit may cause static electricity. How to install the water supply mop kit 1 Wet mops thoroughly with clean water, then wring water out.
Water supply mop kit & Mop maintenance Washing the mops You can use included silicon brush for easier mop washing. 1 Wet mops thoroughly. 2 Use a natural detergent for washing mops. 3 Squeeze out water and dry them under the sun light. Maintaining the water supply mop kits 1 Separate the water supply mop kit from the main unit when cleaning operation is finished. • Pull out the water supply mop kit by hands. • If it is hard to pull out, twist it a little bit.
Cleaning operation & Remote control Caution Do not use the main unit without the water supply mop kit, as it may damage the device. Start cleaning 1 Press and hold the Operation button for 2 seconds until it beeps and the light stays on. Caution 2 To start cleaning, either press the Operation button on the main unit, or press the Start/Stop button on the remote control. • Stop the cleaning process by either pressing the Operation button on the main unit or the Start/Stop button on the remote control.
Cleaning modes Note Select a cleaning mode you want by using the remote control. Auto Basic cleaning mode that effectively cleans the whole area. Edge Focuses on cleaning corners and edges of floor. Focus Intensively cleans the surrounding area relative to the main unit location. Intensive Intensively cleans with straight and circling moving patterns. Pattern Thoroughly clean with ‘ ’ curve pattern as if wiping the floor by hands.
Handy Cleaning mode & Product maintenance Note • User can clean manually by holding the handle of the main unit. • This mode is good to clean desks, tables, glass floors, and glass windows. How to use Handy Cleaning mode Lift the main unit by the handle, and press the Operation button twice quickly. Caution Press the Operation button if you want to stop the Handy Cleaning mode.
LED indications Description of LED lamp When using Blue Blue Blinking • Change mops, and fill water in the water supply mop kit and start the cleaning again. Yellow On • Recharge the battery. * If the battery is low while cleaning a dark place, the unit moves out to a bright place and stops operation. Yellow Yellow Blinking • Check whether the unit stopped due to an obstacle. • Check whether there are foreign substances in the mop guide kit or water supply mop kit.
Troubleshooting The unit does not turn on. • The battery may not be charged. • Recharge the battery fully and start the main unit again. The main unit does not charge. • Check if the power adapter is correctly connected. Remote control does not work. • • • • Check if the main unit is turned on. Replace the remote control batteries with new ones. The remote control does not operate while the main unit is recharging. Check that the main unit is within range of the remote control (16 ft/5 m).
Product Specifications Main Unit 6.5 in 5.35 in 12.87 in Product Name Electric Floor Sweeper (Floor Mopping Robot Cleaner) Model Name Mopping Robot Power Consumption 27 W Size W12.87 x D6.5 x H5.35 in Weight 3.5 lb Power 100-240 V~, 50-60 Hz Battery Li-ion DC 11.1 V, 2150 mAh Operating Noise 63 dB (Auto Cleaning mode) Operating Time 100 min Driving Speed 20 cm/sec Remote Control Product Name IR Remote Control Model Name VR6000TM IR Size W5.90 x D1.97 x H0.83 in Weight 0.
If you have any questions or comments relating to Samsung products, please contact a local Samsung service center. Country Customer Care Center Web Site CANADA 1-800-SAMSUNG (726-7864) 1-844-SAM-PAYS (726-7297) www.samsung.com/ca/support (English) www.samsung.com/ca_fr/support (French) U.S.A 1-800-SAMSUNG (726-7864) 1-844-SAM-PAYS (726-7297) www.samsung.com/us/support Rev 0.2 VR6000TM_UM_Mopping-Robot_NA_EN.
