Operation Manual

73
The problem Try this!
The Anynet+ device won't
play.
You cannot use the play function when Start Setup is in progress.
The connected device is not
displayed.
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
Go to Anynet+ (HDMI-CEC) ( Settings System Expert Settings
Anynet+ (HDMI-CEC)) and see if Anynet+ (HDMI-CEC) has been set to On.
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure
the device is connected to your TV with an HDMI cable. Some HDMI cables may
not support Anynet+.
If the connection is terminated because there has been a power failure or the
HDMI cable has been disconnected, please scan for the device again.
The TV audio is not being
played through the receiver.
Connect an optical cable to the TV and the receiver.
ARC enables the TV to output digital sound via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver
that supports ARC.