Operation Manual

installation & connection
44_ installation & connection
Power Supply (SNV-7084)
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
`
If you turn on PoE and DC12V and AC24V at the same time, the first applied one will be used as
the power source.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE 802.3af protocols.
`
The heater operates at a low temperature environment in all cases that the dome camera is
operated by PoE, AC 24V or DC 12V.
- Install the product at the temperature of -35°C or higher.
- The product can be operated down to the temperature of -40°C after it started up.
`
Be careful not to reverse the polarity when you connect the power cable.
`
AC 24V can be connected in non-polar union.
`
If you want to connect an external device, you must turn off the external device before proceeding.