Manual

INS_SBP-C03_REV– 08/12/19 PAGE 1

INSTALLATION AND OPERATION MANUAL

SBP-C03

1 RU HIGH 3 UNIT CARD CAGE WITH POWER SUPPLY

The SBP-C03 is a 1 RU (1.75”) high 19-inch rack-mountable card cage unit capable

of mounting up to three 1.0-inch modules.

The SBP-C03 is provided with one external 120-240 VAC power supply with a 12VDC

at 3A output, and includes reverse polarity protection. Two separate isolated DC

inputs are provided for mission critical/high reliability applications where power

supply redundancy is required. PoE (Power over Ethernet) modules may also be

used, by replacing the power supply with a +48VDC unit, and connecting the

supply output to the DC power input of each PoE module. See Module Instructions

for wiring instructions.

Any module may be hot-swapped without any impact to the operation of the other

modules within the card cage.

Ideally suited to those applications where rack space may be limited, the SBP-C03

may be used in desktop installations by the addition of user-installed rubber feet on

the bottom of the cage. It may also be installed as a rack by use of the two included

rack-mount adapter brackets. See Page 2 for installation instructions.

PAGE 1
SBP-C03 INSTALLATION AND OPERATION MANUAL SBP-C03 1 RU HIGH 3 UNIT CARD CAGE WITH POWER SUPPLY The SBP-C03 is a 1 RU (1.75”) high 19-inch rack-mountable card cage unit capable of mounting up to three 1.0-inch modules. The SBP-C03 is provided with one external 120-240 VAC power supply with a 12VDC at 3A output, and includes reverse polarity protection. Two separate isolated DC inputs are provided for mission critical/high reliability applications where power supply redundancy is required.
PAGE 2
INSTALLATION AND OPERATION MANUAL SRM-C03 FIGURE 1 – SBP-C03 CARD CAGE TOP COVER REAR PANEL FRONT PANEL Optional Rack Mount Adapter Bracket Kit (Included) Optional Rubber Feet (Included) INS_SBP-C03_REV– 08/12/19 PAGE 2
PAGE 3
INSTALLATION AND OPERATION MANUAL SRM-C03 FIGURE 2 – SBP-C03 WIRING INSTRUCTIONS REAR PANEL – REDUNDANT POWER SUPPLY CONNECTORS GND + Redundant Power Supply Connectors are located on the rear panel of the SBP-C03 Rack. Each input should be supplied with 12 VDC, minimum 2 Amps. The lower pin on connector A and connector B is connected to the positive lead from the power supply. The upper pin is connected to ground. Most power supplies feature a legend that denotes the polarity of the supply wires.