Owner Manual
English 51
Troubleshooting
Problem Action
Stops.
• Make sure the washer's power cord is fully plugged in and
the circuit is live.
• Check the fuse or reset the circuit breaker.
• Close the door, and then press or tap Start/Pause (Hold to
Start) to start the washing machine. For your safety, the
washing machine will not spin unless the door is closed.
• Before the washing machine starts to ll, it will make a
series of clicking noises to check the door lock, and then
does a quick drain.
• There may be a pause or soak period in the cycle. Wait
briey and the washing machine may start.
• Make sure the inlet hose lters at the taps are not clogged.
Periodically clean the lters. See page 47.
• This problem can occur temporarily due to low voltage in
your household electrical system. It will be resolved when
the voltage returns to normal.
Fills with the wrong
temperature water.
• Fully open both water taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct water
taps. Flush the water lines.
• Disconnect the hoses and clean the mesh lters. The water
inlet mesh lters may be clogged. See page 46.
• While the washing machine lls, the water temperature
may change as the automatic temperature control feature
checks incoming water temperature. This is normal.
• While the washing machine lls, you may notice just hot
and/or just cold water going through the dispenser when
cold or warm temperatures are selected. This is a normal
function of the automatic temperature control feature as
the washing machine determines the water temperature.
Door (Lid) locked or will
not open.
• While the washing machine is operating, press or tap
Start/Pause (Hold to Start) to stop the washing machine.
• It may take a few moments for the door lock mechanism to
disengage.
Untitled-1 51 6/20/2019 2:25:00 PM