Side By Side Refrigerator Owner's Manual

CHECKING THE WATER DISPENSER LINE

1) In order to operate the ice maker properly, water pressure of 20 ~125 psi is required.

In this range a 170 cc (5.74 ounces) paper cup can be filled in 10 secs.

2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.

3) If the refrigerator is installed in an area with low water pressure (below 20psi), you should install a

booster pump to compensate.

4) Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis-

penser lever until the water runs from the outlet.

NOTE

Water line installation kit is available at extra cost from your dealer. The refrigerator

manufacturer recommends using a water supply kit containing copper tubing.

Connecting to water supply line

- Shut off the main water supply line and turn

the Ice maker to the off position.

- Locate the nearest cold drinking water line.

- Follow the instructions in the ice maker

installation kit.

- After connecting the water supply with water

filter, turn on water supply and flush 4 or

more gallons into a bucket to clear the water

filter

1. Cold Water line

2. Pipe Clamp.

3. Water Line Installation Kit

4. Shut Off Valve

DA68-01506C(0.1)EN-1 2006.5.6 11:45 AM 페이지26