Side by Side Refrigerator Model RS2530BWP User Manual

2) Please adjust the height difference between the doors by turning the bolt (➁) clockwise ( ) or

counter clockwise ( ).

INSTALLATION INSTRUCTIONS

ADJUSTING THE HEIGHT BETWEEN THE DOORS

Making small level adjustments between doors.

If the door of the freezer is lower than that of

the fridge.

If the door of freezer is higher than that of the

fridge.

3) After adjusting the doors, turn the nut clockwise ( ) until it reaches the lower end of the

bolt, then tighten the bolt again with the wrench (➂) to fix the nut(①).

If you do not fix the nut (①)firmly, the bolt (➁) may be released.

Adjustment part

➂ WRENCH➂ WRENCH

➀ NUT

➁ BOLT

➀ NUT

➁ BOLT

➂ WRENCH

➁ BOLT

Please open the doors and adjust them as follows:

1) Release the nut (

①

) on the lower hinge until it reaches the upper end of the bolt (

➁

When you release the nut (①), use enclosed hex wrench (➂) to turn the bolt(➁) in a slightly

counterclockwise direction. This will enable you to loosen the nut(①) with your fingers.

When you turn clockwise ( ), the door goes up.

NOTE

➀ NUT

➂ WRENCH

➀ NUT

➁ BOLT

➂ WRENCH

➀ NUT

➁ BOLT

DA68-01606B(0.0)-EN 2/28/07 3:24 PM Page 23