Use and Care Manual

English - 17
01 SETTING UP
Installing the water filter.
Before installing the water filter, please
remove the top shelf.
1. Remove the water filter cover (1).
2. Remove the fixed cap by turning it counter
clockwise.
Keep the cap in a safe place for later use if you
don’t use a filter.
3. Remove the water filter from the box and put
a replacement indicator sticker on the filter as
shown.
Place a sticker on the filter with a date six
months in the future.
For example, if you install the water filter in
March, put the “SEP” sticker on the filter to
remind you to replace it in September.
That way you’ll know when it is time to replace
the filter.
Normal filter life is about 6 months.
1
(1)
Sticker
(month indicator)
2 3
4. Remove the filter cap and insert the filter into
the filter housing.
5. Slowly turn the water filter 90º clockwise to
align the indicator mark on the filter with lock
indicator on the filter housing.
Make sure to align the water filter label
mark with the center of the lock indicator as
illustrated above, right. Do not over-tighten.
4 5
Cover filter
Remove the red cap
Align the indicator mark
on the filter with the
lock indicator on the
filter housing.
A newly installed water filter cartridge may
cause water to briefly spurt from the water
dispenser.
This is caused by air getting into the line.
It should pose no problem to operation.
DA68-02966A-00.indb 17 2013. 11. 29. �� 4:12