Operation Manual
English 35
Setting up
select the location where the purier is to install. (Model with the purier)
TAP
TAP
COUPLER (A)
COUPLER (A)
• If you wish to reassemble the water
inlet and outlet sides of the purier
during purier installation, see the
reference illustration.
Water inlet side of purier
Line outlet
Side of puri
er
Purier water
90°
Coupler
• Cut the water line attached to the
purier to the appropriate place after
measuring the distance between the
purier and the cold water tap.
Locking clip
CAUTION
Insert Locking Clip After tube seated
Remove any residual matter inside the purier (model with the purier)
Outlet side
Outlet side
Of purier
Water
Purier
Water line
• Open the main water tap to check
whether water is running through the
water tube on the water inlet side of
the purier.
• If water does not come out through the
line, check whether the tap is open.
• Leave the tap open until clean water
is running out and any residual matter
that built up during manufacturing has
been removed.
NOTE
The initial dark discoloration of water and
ice is normal.
DA68-03176A (EN)-00.indd 35DA68-03176A (EN)-00.indd 35 2015. 1. 14. 2:502015. 1. 14. 2:50