User manual
10_ setting up
Be careful not to drop and scratch the doors while
removing the doors.
With the door opened, remove the cap top table ( ) with
a flat-blade screwdriver(-), and close the door. Remove the
3 screws holding down the top table ( ) and turn it with
several wires connected.
Disconnect one connector ( 3 ) on the
right side door and one connector ( 4 )
on the left side door. Remove the water
line ( 5 ) while pressing the dark gray
color part ( 6 ) of the water line coupler.
If a red clip is on the coupler, it must
be removed before removing the
tube.
Remove the 3 hex head bolts ( 7 ) attached to the upper left
and right door hinges with a socket wrench(10mm). Remove
the ground screw ( 8 ) attached to the upper left and right door
hinges with a philips screwdriver(+). Remove the upper left and
right door hinges ( 9 ).
Lift the door straight up to remove.
Remove the screw( 10 ) attached to the lower left and right
door hinges with a philips screwdriver(+). Remove the 2 hex
head bolts( 11 ) attached to the lower left and right door
hinges with an allen wrench(3/16”). Remove the lower left
and right door hinges ( 12 ).
WARNING
1
2
CAUTION
4
5
6
3
Socket wrench
7
8
9
Allen wrench
12
10
11
AW3.indd 10 2010.3.4 2:32:44 PM