User Manual

English - 11
REMOVING THE
REFRIGERATOR DOORS
For some installations, you need to remove the
fridge doors and freezer drawer so you can
move the refrigerator to its final location. Do not
remove the doors/drawers if you don’t need
to. If you do not need to remove the refrigerator
doors or drawers, go to ‘Adjusting the Level’
on page 14. If you need to remove the doors
and drawers. continue below. Before removing
the doors or drawers, make sure you read the
following warnings:
WARNING
Disconnect power to the refrigerator before
removing the door or drawer.
• Be careful not to drop, damage,
or scratch the doors/drawer while
removing them.
• Be careful not to injure yourself while removing
the doors/drawer.
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
WARNING
Disassembling the refrigerator doors
Be careful not to drop and scratch the doors while
removing them.
With the door opened
1. Remove the 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
1
2. Disconnect the two connectors ( 2 ) on the
left side door. To remove the water coupler
from the hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
CAUTION
If a red clip is on the coupler, you must remove it
before removing the tube.
2
3
4
Red Clip
(1/4")
3. Pull and remove the hinge lever ( 5 ). Remove
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
5
6
7
4. Lift the door straight up to remove.
DA68-02601G-00.indb 11 2014. 12. 4. �� 3:05
01 SETTING UP