User Manual

English 37
Maintenance
Self-cleaning (Single mode only)
This self-cleaning oven uses high temperatures (well above cooking temperatures)
to burn off leftover grease and residue completely or reduce them to a nely
powdered ash that you can wipe away with a damp cloth.
CAUTION
• Do not leave small children unattended near the gas oven during the self-
cleaning cycle. The outside surfaces of the gas oven can get extremely hot.
• Some birds are extremely sensitive to fumes from a self-cleaning gas oven.
Relocate birds to a well-ventilated room away from the gas oven.
• Do not line the oven, oven racks, or oven bottom with aluminum foil. Doing
so will result in poor heat distribution, produce poor baking results, and cause
permanent damage to the oven interior. The aluminum foil will melt onto and
adhere to the interior oven surfaces.
• Do not force the oven door open during the self-cleaning cycle. This will
damage the automatic door-locking system. The door automatically locks
when the self-cleaning cycle is started and stays locked until the cycle is
cancelled and the oven temperature is below 392 °F.
• Use caution when opening the oven door after the self-cleaning cycle. The
gas oven will still be VERY HOT and hot air and steam might escape when the
door is open.
• Wipe off any excess spillage before using the self-cleaning operation.
• Do not use oven cleaners. Commercial oven cleaners or oven liners should
NEVER be used in or around any part of the oven. Residue from oven cleaners
will damage the inside of the oven during a self-cleaning operation.
7
8
6
Top Bottom
6. Return the burner heads to their
positions on top of the manifold
valves. Make sure a starter electrode
is inserted through the hole in each
burner head.
7. Return the burner caps to their
positions on top of burner heads. To
ensure proper and safe operation, make
sure the burner caps lie at on top of
the burner heads.
8. Reinstall the burner grates in their
respective positions.
9. Turn on each burner and check if it
operates properly. After verifying that
a burner operates normally, turn it off.
NOTE
• Check the right position of the Double
ring burner.
• The precise simmer burner(RR) cap and
the inner Double ring burner (RF) cap
are interchangeable.
CAUTION
• The starter electrodes are not removable. Do not attempt to remove them by
force.
• Make sure all burner components (heads and caps) are reinstalled properly.
They are stable and rest at when installed properly.
• To avoid chipping, do not bang grates and caps against each other or hard
surfaces such as cast iron cookware.
NX58J7750S_AA_AC_DG68-00623A-07_EN+CFR.indb 37 2018-08-30  12:22:06