Product Datasheet/Brochure

50 English

Maintaining your appliance

Removing metal marks and scratches

1. Be careful not to slide pots and pans across your cooktop. It will leave marks

on the cooktop surface. You can remove these marks by applying ceramic

cooktop cleaner with a cleaning pad for ceramic cooktops.

2. If pots with a thin overlay of aluminum or copper are allowed to boil dry, the

overlay may leave black discoloration on the cooktop. You should remove this

discoloration immediately or it may become permanent.

WARNING

Carefully check the bottoms of pans for roughness that may scratch the cooktop.

Cleaning the cooktop seal

To clean the seal around the edges of

the glass, lay a wet cloth on it for a few

minutes, then wipe clean with a nonabrasive

cleaner.

Potential for permanent damage to the glass surface

• Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can

cause pitting of the surface of your cooktop. This is not covered under the

warranty. You should clean the spill while it is still hot. Take special care when

removing hot substances. Refer to the following section.

• When using a scraper, be sure it is new and the razor blade is still sharp. Do

not use a dull or nicked blade.

Cleaning sugary spills and melted plastic

1. Turn off all surface units. Remove hot pans.

2. Wearing an oven mitt, use a single-edge razor-blade scraper to move the spill

to a cool area of the cooktop. Remove the spill with paper towels.

3. Any remaining spillover should be left until the surface of the cooktop has

cooled.

4. Don’t use the surface units again until all of the residue has been completely

removed.

NOTE

If pitting or indentations in the glass surface have already occurred, the cooktop

glass will have to be replaced. In this case, service will be necessary.

Removing and re-installing the oven door

How to remove the door

CAUTION

• The door is very heavy. Be careful when removing and lifting the door.

Do not lift the door by the handle.

• Turn the power OFF before removing the door.

Hinge lock

Locked position Unlocked position

1. Open the door completely.

2. Pull the hinge locks down toward the door frame to the unlocked position.