User Manual

5
FrançaisEspañolDeutschItaliano EnglishPortuguese
Figure 3. Connecting your monitor to a PC
1
Turn off your system and unplug its power cord.
2
Place the FPD facedown on a cushion (being careful not to harm the screen) so that
you can access the cable connectors along the bottom of the rear recess.
3
When connecting your FPD to a computer: Connect the supplied signal cable to the
15-pin mini D-sub connector Á on the back of your FPD. Connect the other end of the
cable to the video port on the back of your computer.
When connecting your FPD to a workstation: Connect an optional signal cable to the
13W3 connector  on the back of your FPD. Connect the other end of the cable to the
video port on the back of your workstation. An adapter may be required.
NOTE: One or both types of signal cables can be connected to the FPD,
simultaneously.
4
Connect the power adapter jack to the power port ¬ on the back of the FPD. To
prevent dislodging the jack, slide the power adapter cable into the cable holder. Insert
the cable holder into the holder slot and turn it 1/4 turn. Connect the proper power
cord for your locale to the AC inlet on the power adapter.
5
Place your FPD upright on your desk and plug the power cords from your system and
your FPD into a nearby outlet.
6
Turn on your system and FPD. If your FPD displays an image, installation is complete.
7
Perform the auto adjustment procedure as described in “Auto Adjustment” on page 6
1
To workstation
video port
2
3
4
5
6
Installation
sa800e2.fm Page 5 Monday, May 29, 2000 2:09 PM