Use and Care Manual

 - English


▶
If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall
wherever you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully
hang each speaker on a screw or nail.
▶
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
▶
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
▶
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands
or alien substances into the duct (hole) of the subwoofer speaker.
▶
Do not hang the subwoofer on the wall using the duct (hole).
▶
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water
and moisture.
▶
For optimal listening performance, make sure that the area around the wireless receiver module
location is clear of any obstructions.
▶
In 2-CH mode, you will hear no sound from the wireless surround speakers.
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless Receiver
Module (SWA-6000)
If you attach a Toroidal ferrite core to the power cord of the wireless receiver module, it will help prevent RF
interference from radio signals.
 Pull the fixing tab of the Toroidal ferrite core to open it.
 Make two loops in the wireless receiver module power cord.
 Attach the Toroidal ferrite core to the wireless receiver module's
power cord as shown in the figure on the right, and then close it
by pressiing it until it clicks.

Attach the ferrite core as close to the Wireless Receiver Module
as possible.