User Manual

58_ setup
setup
SETTING THE NETWORK
You can set various network functions, such as monitoring live video by connecting to a network from a remote location
and receiving an event by e-mail.
IP & Port
You can set the network connection route and protocol.
Setting a network connection
Sets the protocol and environment of the network.
Setup > Network > IP & Port > IP address
●
Network : The network port can be used as a common port for camera and web viewer connection. Click
<Setup> of the network connected to the recorder.
– IP type : Select the type of network access.
– IP address, Subnet Mask, Gateway, DNS
￭
Manual : IP address, subnet mask, gateway, and DNS can be directly entered.
￭
DHCP : IP address, subnet mask, gateway, and DNS can be automatically set.
●
Transfer bandwidth : Enter the max data volume of a rate for transfer.
￭
The DNS value of DHCP can be directly entered only if you have selected <Manual>.
Text Event Settings
You can set the text to receive an alarm when an event occurs.
Setup > Device > Text > Event
●
Total amount : Set the condition of the total amount to be notified when a text event occurs. Check whether
the total amount is used, and then select the base amount and range.
●
Keyword : You can register or delete keywords to be notified when an event occurs.
– If the <Add> button is clicked, a screen to add keywords pops up.
– If you select one of the added keywords to delete and click the <Delete> button, the selected keyword will
be deleted.
￭
When entering the total amount, set it to 15 characters or less, including minus and decimal point.
￭
When entering keywords, set them within 50 characters. Up to 20 keywords can be specified.
Serial
You can set the serial port (RS485 or RS422) of the recorder.
Configure the same settings as the analog PTZ camera or system keyboard to be linked.
Setup > Device > Serial
￭
Some models support RS485 only.