Installation Guide

E-

Fixing the Installation Plate

Purging the Unit

Before fixing the installation plate to a wall or window frame, you

must determine the position of the 65 mm hole through which the

cable, piping and hose pass to connect the indoor unit up to the

outdoor unit. When facing the air conditioner in position on the wall,

the piping and cable can be connected from the:

Right

Left

Rear (right or left)

1 Determine the position of the pipe and drain hose hole using the right

figure and drill the hole with an inner diameter of 65 mm so that it slants

slightly downwards.

2 If you are fixing the indoor unit to a... Then follow Steps...

Wall 3.

Window frame 4 to 6.

3 Fix the installation plate to the wall in a manner appropriate to the weight

of the indoor unit.

If you are mounting the plate on a concrete wall with anchor

bolts, the anchor bolts must not project by more than 20 mm.

4 Determine the positions of the wooden uprights to be attached to the

window frame.

5 Attach the wooden uprights to the window frame in a manner appropriate

to the weight of the indoor unit.

6 Using tapped screws, attach the installation plate to the wooden uprights,

as illustrated in the last figure opposite.

INSTALLING THE UNIT

mm03

Installation plate

Pipe hole

(

65mm)

On delivery, the indoor unit is loaded with an inert gas. All this gas

must therefore be purged before connecting the assembly piping.

To purge the inert gas, proceed as follows.

Unscrew the caps at the end of each pipe.

Result: All inert gas escapes from the indoor unit.

To prevent dirt or foreign objects from getting into the pipes

during installation, do NOT remove the caps completely until

you are ready to connect the piping.

(Unit : mm)