User's Manual

Health and safety information
Exposure to Radio Frequency (RF) Signals
Certification Information (SAR)
Your wireless tablet is a radio transmitter and receiver. It is designed and manufactured
not to exceed the exposure limits for radio frequency (RF) energy set by the Federal
Communications Commission (FCC) of the U.S. government. These FCC exposure limits
are derived from the recommendations of two expert organizations, the National Counsel
o
n Radiation Protection and Measurement (NCRP) and the Institute of Electrical and
Electronics Engineers (IEEE). In both cases, the recommendations were developed by
scientific and engineering experts drawn from industry, government, and academia after
extensive reviews of the scientific literature related to the biological effects of RF energy.
The exposure limit set by the FCC for wireless mobile tablets employs a unit of
m
easurement known as the Specific Absorption Rate (SAR). The SAR is a measure of
the rate of absorption of RF energy by the human body expressed in units of watts per
kilogram (W/kg). The FCC requires wireless tablets to comply with a safety limit of 1.6
watts per kilogram (1.6 W/kg). The FCC exposure limit incorporates a substantial margin
of
safety to give additional protection to the public and to account for any variations in
measurements.
SAR tests are conducted using standard operating positions accepted by the FCC w ith
the tablet transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level
of the tablet while operating can be well below the maximum value. This is because the
tablet is designed to operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to a wireless base station
antenna, the lower the power output.
Before a new model tablet is available for sale to the public, it must be tested and
certified to the FCC that it does not exceed the exposure limit established by the FCC.
T
ests for each model tablet are performed in positions and locations (e.g. at the ear and
worn on the body) as required by the FCC.
Non-compliance with the above restrictions may result in violation of FCC RF exposure
guidelines.
SAR information on this and other model tablets can be viewed on-line at
www.fcc.gov/oet/fccid. This site uses the tablet FCC ID number A3LSMT815.
Sometimes it may be necessary to remove the battery pack to find the number. Once you
have the FCC ID number for a particular tablet, follow the instructions on the website and