User's Manual

Ver.

Mobile WiMAX/TD-LTE Smart MBS, U-RAS Flexible V2 RRH-B4 Installation Manual

2600-00F1W8GAA

4.0

Figure C.7 TNC-male Connector Assembling (2)

5) Push a connector into the end of the cable.

Then, push it further until the center conductor is

firmly inserted into the pin connection part of the

N-Type male body.

Make the shield overlap the N-Type male body, pull

out the clamp ring, and let it go to its original

position so that the remaining len1/2 in. be folded.

6) Cut off the folded length of the shield using a

cutting device so that it does not protrude outside

when the clamp ring is inserted.

After arranging the shield, push up the clamp ring

toward the connector until the entire shield is

covered.

7) Using a compressor and hexagonal dies,

pressurize the clamp ring to fix the cable and

connector.

8) Lift the heat shrink tube up to the connection point

on the connector and shrink the heat shrink tube

using a heating gun.