User Manual

9
Concert 288 Dual Channel Wireless System
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
1 2
3 34 4
7 8 9
5 6 6 5
1. Antennas - The antenna mountings allow full rotation for optimum placement. In
normal operation, both antennas should be placed in a vertical position. Both
antennas can be folded inward for convenience when transporting the CR288.
2. VOLUME Control (CH A) - This knob sets the level of the audio signal being output
through the CH A output jacks on the rear panel. Reference level is obtained
when the knob is turned fully clockwise (to its “10” setting).
3. SELECT Button - Press this button to cycle through the each receiver's operating
channels. Press and hold this button to send the channel information to the
transmitter via infrared transmission.
4. PEAK Indicator - This indicator lights red when the corresponding transmitted
audio signal is overloaded.
5. READY Indicator - This indicator lights green when the corresponding receiver
channel is receiving RF signal and the system is ready to use.
6. LED Display - The 7-segment LED display shows each receiver's current operating
channel. The channels are indicated by 0-9 and A-F.
7. IR Transmitter - During “IR SET” an infrared light is used to set the transmitter
channel.
8. VOLUME Control (CH B) - This knob sets the level of the audio signal being output
through the CH B output jacks on the rear panel. Reference level is obtained
when the knob is turned fully clockwise (to its “10” setting).
9. POWER Switch - Use this to turn the CR288 power on and off.
CR288 Receiver Callouts