Product Manual

1
TM
Installation Instructions
TGS01B Salt Spreader
—continued inside
WARNING
Observe the following Safety Precautions before, dur-
ing and after operating this spreader. By following
these precautions and common sense, possible injury to
persons and potential damage to this machine may be
avoided.
SPREADER WARRANTY INFORMATION
This warranty replaces all previous warranties and
no employee of this company is authorized to extend
additional warranties, or agreements, or implications
not explicitly covered herein.
Buyers Products Company warrants all parts of the
product to be free from defects in material and work-
manship for a period of one (1) year. Parts must be
properly installed and used under normal conditions.
Normal wear is excluded.
Any part, which has been altered, including modifica-
tions, misuse, accident, or lack of maintenance will
not be considered under this warranty.
The sole responsibility of Buyers Products Company
under this warranty is limited to repairing or replac-
ing any part(s), which are returned, prepaid, 30
days after such defect is discovered, and returned
part(s) are found to be defective by Buyers Products
Company.
Authorization from Buyers Products Company must
be obtained before returning any part. The following
information must accompany defective parts returned
to Buyers Products Company: RMA #, spreader model,
serial number, date installed, and distributor from
whom purchased.
Buyers Products Company shall not be liable for
damage arising out of failure of any unit to operate
properly, or failure, or delay in work, or for any con-
sequential damages. No charges for transportation
or labor performed on any part will be allowed under
this warranty.
Safety Precautions
1. Read this entire Owners Manual before operat-
ing this spreader.
2. Read all safety decals on the spreader before
operating.
3. Verify that all personnel are clear of the spread-
er spray area before starting or operating this
spreader.
4. Do not adjust, clean, lubricate or unclog material
jambs without first turning off the spreader.
5. Make sure the spreader is securely fastened to
the vehicle in accordance with this manual.
6. Do not operate a spreader that is in need of
maintenance or repairs.
7. Always disconnect the battery before removing
or replacing electrical components.
Spreader Assembly
Check contents of box against parts list to make
sure all components are included. When ordering
replacement or spare parts refer to parts list (fig. 3)
for part numbers.
Installation (fig. 1)
1. Locate and mark center of tailgate.
2. Assembly Angles (24) and Braces (23) as shown
in Fig.1 Use 3/8" carriage bolts, flat washers and
nuts. Do not tighten fasteners at this moment.
3. Center assembly on top of tailgate. Lower angle
must be flush with top and inside surfaces of
tailgate.
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone [phone] • Fax [phone]
Toll-Free Fax [phone] • saltdogg.com