Installation Guide

Plastic Lockers – 98000 Series
Models 98168 & 98368 Eight Tier
Assembly Instructions
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 01, 12/8/2010) Page 2 of 3
Step 7. Stack the three (3) upper units onto the lower unit. Press all
units firmly together. Use a soft rubber mallet if necessary.
Step 8. Insert one (1) of four (4) divider panels in between each of
the horizontal panels previously installed. The panels slide in
grooves in the side panels and may need the use of a soft rubber
mallet to fully engage the two small latch pins into the holes in the
front edge of the side panels.
Step 9. Attach the plastic oval lock plate to the front of the eight (8)
doors with two (2) screws from the rear of the door. Do not over
tighten. Insert the stainless steel hasp through hole in front of doors
making sure cutout is facing downward. Secure by threading nut
provided onto it from the rear. Insert lock knob through hasp from
front of door making sure hole in lock knob is positioned downward.
Attach cam to rear of lock knob shaft with screw provided. Be sure
the cam is pointing horizontally toward the outside of the door when
the lock knob is positioned vertically, and is properly engaged with
the square shaft on the end of the lock knob.
Step 10. Fasten the eight (8) hinges (one (1) for each of the eight (8)
doors) provided in the hardware package securely to each hinge
position with the screws provided as shown below. Fasten each of
the eight (8) doors to the appropriate hinge. Ensure that the molded
pin in the upper right corner of each door is engaged in the mating
hole in the corner of the underside of each horizontal panel.
PANEL WITH
FILLER STRIPS
(IF NO OPTIONAL
SLOPING HOOD)
BASE PANEL
(THICKER)
CAM
LOCK
PLATE
HASP
LOCK
KNOB
NUT
ALL
UNITS
STACKED
SCREWS
(2)
NAMEPLATE
(OPTIONAL)
SCREW
DOOR
HINGE
DIVIDER
PANEL
DOOR
HINGE