Installation Guide

Standard Lockers – 61000 Series
Single Tier Installation Instructions
Assembly (continued)
3. Position additional sides, backs, tops, bottoms, and shelves and
fasten in place. See Illustration 3.
4. Add a last side (flange in) and the other leg. See Illustration 4.
5. Attach the door and frame assemblies, ensuring that the front
edges of the sides are inside a frame assembly flange and not
between frames. See Illustration 5.
Illustration 3
Illustration 4
6. Fasten the last door and frame assembly into place, ensuring that
they are all fastened correctly. See Illustration 6.
7. Finally, install coat hooks below the top and lock hole fillers into
the doors. If there are built-in locks, install locks instead of lock hole
fillers.
Illustration 5
Illustration 6
Side Panel Hole Locations for Shelves
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 06, 8/4/2010)