Manual

Heavy Duty Plastic Lockers – 40000 Series
End Panel Installation Instructions
1. Drill five (5) 3/16” diameter holes through each of the exposed locker sides where the end panel is to be attached at the locations
shown in the illustration below.
Do not drill holes into the end panel.
2. Fasten each end panel to its corresponding locker side using the # 6 x 5/8” screws provided. The screws must be inserted through the inside of
the locker and screwed into the end panel. The screws should not protrude through the end panel.
INSTALLATION OF END PANELS
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
www.lockers.com engineering
@lockers.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 05, 1/13/2010) Page 6 of 6