Installation Sheet

Figure 14 – Align units up next to each other.
Figure 16– Secure units together using connector machine screws
Figure 15 – Butt each unit’s trim up against the other.
STEP 4
If necessary, repeat this process for addi-
tional units to be installed.
STEP 5
Attach the last mailbox unit used in your
installation to the wall framing on the op-
posite side of the rough opening using #8
square drive x 2” long wood screws.
This completes installation of your mail-
boxes using the 4C Connector Kit(s).
Page 5 of 6
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes
no product assembly or installation liability. Copyright © 2015 Salsbury Industries. All rights reserved. (Rev. 20, 02/10/2017)
SALSBURY INDUSTRIES
1010 East 62nd Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone] Fax: [phone] Int’l Fax: [phone]
www.mailboxes.com [e-mail]