Instructions / Assembly

Figure 2
Connector kit
mounting hole
2 x 4
mounting hole
Page 3 of 6
Figure 3 – Top side of unit facing wall
Overtightening beyond initial contact with frame could hinder functionality. If overtightening occurs, simply back out each overtightened mounting screw.
Figure 5 – Top of unit
Figure 4 – Bottom side of unit facing wall
Figure 6 – Bottom of unit
Locate the 2x4 mount-
ing holes on the inside
corner of the mailbox’s
trim panel (see figure 2
to see the difference be-
tween the 2x4 mounting
holes and the connec-
tor kit mounting holes).
Attach unit to the 2x4
wood framing (using
the provided #8 square
drive x 2” long wood
screws) on the side, top
and bottom sections of
the mailbox unit (see
figures 3 through 6
below).
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes
no product assembly or installation liability. Copyright © 2015 Salsbury Industries. All rights reserved. (Rev. 20, 02/10/2017)
SALSBURY INDUSTRIES
1010 East 62nd Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone] Fax: [phone] Int’l Fax: [phone]
www.mailboxes.com [e-mail]