Instructions / Assembly

ManualsBrandsSalsbury Industries ManualsHardware3400 Horizontal Series 20-Compartment 2-Parcel Locker Pedestal Mount Mailbox

SALSBURY INDUSTRIES

1010 East 62

Street, Los Angeles, CA 90001-1598

Ph: 1-800-624-5269 Int’l Ph: 323-846-6700

Fx: 1-800-624-5299 Int’l Fx:

323-846-6800

Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.

With its high quality design and construction, Salsbury’s 3400 series 4C Pedestal Mailboxes will provide years of maintenance free service. Please

read this entire document before beginning installation.

WARNING: The mailbox unit with installed pedestal must be mounted to a surface of sufficient load bearing

strength. Attachment must be with fasteners that can adequately support the weight of the mailbox unit and pedestal

from static and wind load conditions. Installing to a deficient load bearing surface and/or use of inadequate fasteners

could cause the Pedestal Mailbox unit to tip over possibly resulting in serious injury. See below for further information.

Install Pedestal to Cabinet

1. Lay mailbox unit on its back to install pedestal to the cabinet as

shown below. Mailbox unit is heavy, always get assistance to

lift and move.

2. Fasten pedestal to mailbox bottom using four (4) 3/8” hex bolts

and 3/8” washers provided. For added security, fasten the

pedestal to mailbox bottom using a 3/8” shear away bolt

provided in lieu of any one of the 3/8” hex bolts. Tighten the

hexagonal head of shear away bolt until it snaps off. Pedestal is

now not removable.

Install Mailbox Unit to Mounting Surface

1. Use provided template to mark location of pedestal base

anchors.

2. Install anchors (not provided). Use 1/2” diameter anchors of at

least 6 inches.

3. Place provided rubber pad over anchors, see below.

4. Place the mailbox unit with installed pedestal over rubber pad

and anchors.

5. Fasten pedestal to mounting surface with appropriate hardware

(not provided).

4C Pedestal Mailboxes – 3400 Series

Installation Instructions

SHEAR

AWAY

BOLT

RUBBER

PAD