Installation Guide
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Ph: 1-800-624-5269 Int’l Ph: 323-846-6700
Fx: 1-800-624-5299 Int’l Fx:
323-846-6800
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2011 Salsbury Industries. All rights reserved. (5/6/11) Page 1 of 1
With its high quality design and construction, Salsbury’s 3400 series 4C Pedestal Mailboxes will provide years of maintenance free service. Please
read this entire document before beginning installation.
WARNING: The mailbox unit with installed pedestal must be mounted to a surface of sufficient load bearing
strength. Attachment must be with fasteners that can adequately support the weight of the mailbox unit and pedestal
from static and wind load conditions. Installing to a deficient load bearing surface and/or use of inadequate fasteners
could cause the Pedestal Mailbox unit to tip over possibly resulting in serious injury. See below for further information.
Install Pedestal to Cabinet
1. Lay mailbox unit on its back to install pedestal to the cabinet as
shown below. Mailbox unit is heavy, always get assistance to
lift and move.
2. Fasten pedestal to mailbox bottom using four (4) 3/8” hex bolts
and 3/8” washers provided. For added security, fasten the
pedestal to mailbox bottom using a 3/8” shear away bolt
provided in lieu of any one of the 3/8” hex bolts. Tighten the
hexagonal head of shear away bolt until it snaps off. Pedestal is
now not removable.
Install Mailbox Unit to Mounting Surface
1. Use provided template to mark location of pedestal base
anchors.
2. Install anchors (not provided). Use 1/2” diameter anchors of at
least 6 inches.
3. Place provided rubber pad over anchors, see below.
4. Place the mailbox unit with installed pedestal over rubber pad
and anchors.
5. Fasten pedestal to mounting surface with appropriate hardware
(not provided).
4C Pedestal Mailboxes – 3400 Series
Installation Instructions
SHEAR
AWAY
BOLT
RUBBER
PAD