Installation Guide

Outdoor Parcel Locker – 3302
Installation of Arrow Lock
This document covers the installation of the Arrow Lock in the carrier access door. This lock is available only through the USPS and is to be
installed by authorized USPS personnel only.
Installation Procedure
1. Open carrier access door. See Illustration 1.
2. Remove five (5) 10-32 lock nuts with lock support plate. Dispose
of plastic shipping spacer. Use 3/8” socket wrench for lock nuts.
See Illustration 2.
3. Place Arrow Lock in one (1) Arrow Lock security bracket and
position on door. See Illustration 3.
4. Replace one (1) 10-32 lock nut in the rear position to secure the
Arrow Lock security bracket.
5. Install lock support plate as shown.
6. Replace four (4) 10-32 lock nuts. Torque to 25 to 30 inch-pounds.
Overtightening may keep Arrow Lock from operating correctly.
Illustration 1
Illustration 2
Illustration 3
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 07, 7/22/2010)