Installation Guide

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2012 Salsbury Industries. All rights reserved. (Rev. 03, 2/10/12)
Sloping Hood & Angled Side Panel Options
For Open Access Designer Lockers - 30000 Series
Installation Instructions
Thank you for selecting the 30051 or 30052 sloping hood and/or the 30034 or 30044 angled side panel for the 30000 Series Open Access Designer
Lockers. These instructions are intended to assist you in positioning and fastening the sloping hood and angled side panel to the locker.
Sloping Hood Installation Instructions
Place the sloping hood on top of locker with the front edge flush with
the locker body and the sides flush with sides of the locker. Install
two (2) 1-1/4” long self-tapping dry wall screws (provided) through
the ceiling of the locker compartment (from the inside) into the
bottom of the sloping hood. Pre-drill two (2) pilot holes (6) inches
from the front face of the locker with a 1/16” drill bit as indicated.
Angled Side Panel Installation Instructions
Attach the side panel flush with the front of the locker body. Install
two (2) 1-1/4” long self-tapping dry wall screws (provided) in pre-
drilled holes from inside the locker.