Instructions / Assembly

18” Wide Standard Lockers – 18-51000 Series
Single Tier Installation Instructions
Phone: [phone] Int’l Phone: [phone]
Fax: [phone] Int’l Fax: [phone]
www.lockers.com [e-mail]
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2017 Salsbury Industries. All rights reserved. Page 2 of 5 10/25/17
SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Three Wide Locker Assembly
Step 1: Attach a top shelf, a bottom shelf, and the first single coat hook to a back
panel.
Step 2: Turn the back panel on its back with the shelves pointing upward. Attach the
first side panel, the left rear leg, and the first hat shelf to the assembly of Step 1.
Attach a single coat hook with a double bend, this will accommodate the coat rod).
Step 3: Attach the second top shelf, the second bottom shelf, and an additional single
coat hook to the second back panel as in step 1.
Step 4: Simultaneously attach the assembly of Step 3 (second Step 1 assembly), the
second side panel, and the second hat shelf to the assembly of Step 2. Attach two
additional single coat hooks with a double bend and install a coat rod as shown on
page 3.
Step 5: Attach the third top shelf, the third bottom shelf, and an additional single coat
hook to the third back panel as in steps 1 and 3.
Step 6: Simultaneously attach the assembly of Step 5 (third Step 1 assembly), the
third side panel, and the third hat shelf to the assembly of Step 4. Repeat the Step 4
coat hooks instructions to attach additional coat hooks and coat rods.