User Manual

S&C Form 974 5
Software
Downloading Software
IntelliLink® TripSaver II Controller Module Setup Software is available for download only
to customers who have purchased the module. For each controller module purchased,
the user is entitled to install and use S&C IntelliLink TripSaver II Controller Module
Setup Software on no more than two computers at a time. The latest software release is
posted on the S&C Automation Customer Support Portal at www.sandc.com/support/
automation-customer-support-portal.asp. You will need a username and password to
log in to the portal. If you are a new S&C customer, complete the form in the lower section
of the webpage and a new username and password will be sent to you. If you already have
a password, click the Log-In To Secure Site button. Enter the username and password
to log into the portal. Download the installer ILTS Setup-1.165.15712.0 from the portal.
Installing Software
Double-click the downloaded installer le and follow the on-screen instructions. The
installer will automatically install the Microsoft .NET framework onto your computer if
the required .NET version is missing. You will need administrative privileges to nish the
installation.
Launching Software
Click the green ILTS icon on your desktop or in the Start menu to launch the TripSaver
II Controller Module Setup Software. A warning screen will be displayed right after the
software is launched. Read the message carefully and understand the warning.
Proceed by clicking the green I have read and understand the above warning button.
Once you launch the software, you can configure and save settings under the Stand-
alone (offline) mode.