Installation Manual

- 37 -
1.4.3.1 G SENSOR SETUP
The 1.4.3.1 G SENSOR SETUP screen (accelerometer) enables the MDVR to monitor the movement of the
vehicle in 3 Axes (X, Y, Z) and can be used to trigger a response based on the Trigger values set in the G
Sensor Menu. Readings from the sensor may indicate hard braking, acceleration, impact, sharp turns, etc.
This data may be used to evaluate driver and vehicle performance, maintenance cycles and load dynamics.
AXIS(NAME)
(No user entry) The three AXIS of movement of the monitored vehicle are:
X = ROLL Possible high speed into turns relative to load
Y = PITCH Possible Hard braking or acceleration, speed bumps, etc.
Z = YAW Possible bad shocks, uneven road or unsecured load, etc.
DATA
(No user entry) Displays the current G Force reading for each Axis
ENABLE
Select from two options:
ON The selected functions are ‘On’
OFF The selected functions are ‘Off’
TRIGGER(THRESHOLD)
Enter the G Force setting (up to 3 digits) at which to trigger the response
required:
Sends a Trigger when the vehicle G Force is less than or greater than the
trigger setting
TYPE
Select the Type of Trigger response required:
ALARM Sends a trigger to generate an alarm (See 1.4.5.1 ALARM OUT
SETUP)
EVENT Sends a trigger to enter a message in the ALARM/EVENT Log
Action Bar Keys (Select, then press ENTER):
CALIBRATE
Select after installing the MDVRto reorient the G Sensor
SETUP MENU 1.4
'ALARM'
ALARM SETUP 1.4.3
'G SENSOR'
G SENSOR SETUP
1.4.3.1
MASTER MENU 1.4
'ALARMS'
ALARM SETUP 1.4.3
'G SENSOR'
G SENSOR SETUP
1.4.3.1
Mobilemule™