Use and Care Manual

ManualsBrandsRust-Oleum Specialty ManualsPaint11 oz. Gloss Black Lacquer Spray Paint (6-Pack)

TECHNICAL DATA SPC-10

SPECIALTY

LACQUER SPRAYS

Form: GDH-330

Rev.: 042114

.DESCRIPTION AND USES .

Rust-Oleum

Lacquer Sprays is a high luster coating that

provide a smooth, durable, ultra-hard, gloss finish on wood,

metal, and more. Lacquer sprays are ideal for furniture,

lamps, picture frames, and more.

.PRODUCTS .

SKU Description

1904830 Gloss White

1905830 Gloss Black

1906830 Gloss Clear

243826 Chinese Red

. PAINTING CONDITIONS .

Use outdoors or in a well ventilated area. Use when

temperature is between 50-90°F (10-32°C) and humidity is

below 65% to ensure proper drying. Do not apply to

surfaces, when heated, exceed 200°F (93°C). avoid

spraying in very windy and dusty conditions. Cover

surrounding area to protect from spray mist.

. PRODUCT APPLICATION .

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical

contaminants by washing the surface with a commercial

detergent, or other suitable cleaning method. Rinse with

fresh water and allow to thoroughly dry. Remove loose

paint and rust with a wire brush or sandpaper. Lightly sand

glossy surfaces.

Removal of old paint by sanding, scraping or other means

may generate dust or fumes that contain lead. LEAD IS

TOXIC. Contact the U.S.EPA/Lead Information Hotline at

1-800-424-LEAD or log on to www.epa.gov/lead.

.PRODUCT APPLICATION (cont.) .

APPLICATION

Shake can vigorously for one minute after the mixing ball

begins to rattle. If mixing ball fails to rattle DO NOT

STRIKE CAN. Contact Rust-Oleum. Hold can upright 10-

16" from surface and spray in a steady back and forth

motion, slightly overlapping each stroke. Keep the can the

same distance from the surface. Keep the can in motion

while spraying. Apply two or more light coats a few

minutes apart to avoid drips and runs. Do not use near

open flame.

DRY & RECOAT

Dry and recoat times are based on 70ºF (21°C) and 50%

relative humidity. Allow more time at cooler temperatures.

Dries to the touch in 20 minutes and is fully dry in 30

minutes. May recoat at any time.

CLEAN-UP

Clean valve immediately after use by turning can upside

down and depressing spray button for 3-5 seconds (some

paint will be sprayed out, so be careful to not inadvertently

spray yourself or other objects). Clean up wet paint with

xylene or mineral spirits. Properly discard empty container.

Do not burn or place in home trash compactor.

CLOGGING

If the valve clogs, twist and pull off spray tip and rinse in a

solvent such as mineral spirits. Do not insert any object

into can valve opening.

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA SPC-10 SPECIALTY LACQUER SPRAYS .DESCRIPTION AND USES . .PRODUCT APPLICATION (cont.) ® APPLICATION Rust-Oleum Lacquer Sprays is a high luster coating that provide a smooth, durable, ultra-hard, gloss finish on wood, metal, and more. Lacquer sprays are ideal for furniture, lamps, picture frames, and more. .PRODUCTS SKU 1904830 1905830 1906830 243826 Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN.
PAGE 2
TECHNICAL DATA PEEL STOP – LACQUER SPRAYS .PHYSICAL PROPERTIES . Physical Properties FROSTED GLASS SPRAY Resin Type Acrylic Lacquer Pigment Type Proprietary Solvents Acetone, Methyl Ethyl Ketone, Toluene MIR 1.40 Max Fill Weight 12 ounces Practical Coverage at Recommended DFT (assumes 15% material loss) Dry Times at 70-80ºF (21-27ºC) and 50% Relative Humidity Approximately 7 sq.ft./can 2 (0.