Specification

RESTORE 10X Advanced Resurfacer FAQs
Page7of11

above.Ifwatercontinuestobead,thefloorshouldnotbecoated.Ifwatersoaksintothesurface,you
mayproceedtocoatthefloorasdirected.
Q.Myconcretepatioalreadyhaspaintonit.CanIapplythisoveranothercoating?
A.YoucannotapplyRestore10XAdvancedResurfacerdirectlyoveranothercoating.ALLEXISTING
SEALERS,PAINTS,STAINS,WATERREPELLANTSOROTHERFINISHESMUSTBEREMOVEDforRestore10X
AdvancedResurfacertoadhereproperly.Thepr evious
coatingneedstoberemovedusingachemical
stripperoraconcretefloorsander.Aftertheoldcoatingisremovedconductasplashtestbysprinkling
wateronmultipleareasofthesurface.Checkatleast4areas,ormoreforlargerareas.Besureto
checkbothhightraffic
areassuchaswalkwaysandnon‐trafficareas.Ifwatercontinuestobead,the
floorshouldnotbecoated.Ifthewaterabsorbsrapidlyintothesurface,thesurfaceisreadytobe
coated.
APPLICATION
Q.WhatisthebestwaytoapplyRestore10XAdvancedResurfacer?
A.TWOCOATSOFRESTORE10XADVANCEDRESURFACERAREREQUIRED.
USEOFTHERESTOREHONEYCOMBROLLERISREQUIREDFORPROPERAPPLICATION.
ONLYAPPLYRESTORE10XADVANCEDRESURFACERWHENTHEAMBIENTTEMPERATUREWILLBE
BETWEEN50‐90DEGREESFAHRENHEITDURINGAPPLICATIONANDFORAFULL48HOURS(DAYAND
NIGHT)AFTERAPPLICATION.
DONOTAPPLYIFRAINISEXPECTEDWITHIN48HOURSOFAPPLICATION.

TRIMANDVERTICALSURFACES:BeforeapplyingRestore10XAdvancedResurfacertothehorizontal
deck,firstcoatverticalsurfacessuchasdeckposts,railings,orbalusters.Cutinaroundedgeswitha
brushandcoatvisibleareasbetweendeckboards.Forbestresults,useRestore2XOneCoatSolidStain,
Restore4XDeckCoat,orRestoreSolidAcrylicStain.

STEP1:Thoroughlystirmaterialbeforeandduringtheproject.Whenusing morethanonecontainer,
combineallcontainerstoensurecolorconsistency.

STEP2:Usingeithera4”or9”RestoreHoneycombRollersaturatetherollercoverandrollinone
direction,withaslightdownwardpressuretomaintaintextureandtopushmaterialintocracksand
voids.Worktoawetedgeatalltimes.Avoidrollingbackintocoatedareaswhendryinghasbegun.
Coat1to2boardsatatime.

STEP3:Aftercoating1to2boards,useaputtyknifeorotherstraightedgetoremoveanyexcess
coatingbetweendeckboards.Difficultareassuchaswarpedorcuppeddeckboardswillrequirerolling
acrossthenarrowwidthofdeckboardaswellasthelengthtoensurecompletecoverage.

STEP4:Allowfirstcoattodry4‐6hours.Extenddryingtimeifthesurfaceistackyorsoft.Dryingtimes
mayvarydependingontemperatureandhumidity.

STEP5:ApplysecondcoatusingthesamemethodasinSTEP2andSTEP3.
