R USER MANUAL MODEL:OL20-D068C
CONTENTS USER MANUAL 1 BEFORE YOU BEGIN.....................................................1 2 IMPORTANT SAFETY TIPS..........................................3 3 PRODUCT OVERVIEW...................................................7 4 INSTALLATION..............................................................8 5 OPERATION...................................................................10 6 MAINTENANCE............................................................15 7 TROUBLE SHOOTING..............
BEFORE FIRST USE: To prevent any internal damage, it is very important to keep refrigeration units (like this one) upright throughout their journey. Please leave it standing upright and outside the box for 24 HOURS before plugging it in.
1 BEFORE YOU BEGIN Please read the operating instructions carefully before using your dehumidifier for the first time. The dehumidifier is used to remove excessive moisture from the air. The resulting reduction in relative humidity protects buildings and their contents from the adverse effects of excess humidity. The environmentally friendly R134a is used as the refrigerant. R134a has no damaging influence on the ozone layer (ODP), a negligible greenhouse effect (GWP) and is available worldwide.
1.2 THE FOLLOWING SHOULD ALWAYS BE OBSERVED FOR SAFETY This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay persons. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
2 IMPORTANT SAFETY TIPS IMPORTANT NOTICE FOR FIRST TIME USE Be sure the dehumidifier is properly grounded. To minimize shock and fire hazards, proper grounding is important. This power cord is equipped with a three-prong grounding plug for protection against shock hazards. Your dehumidifier must be used in a properly grounded wall socket.
Do not operate with wet hands. Prevent water from spilling onto the unit. Do not immerse or expose the unit to rain, moisture or any other liquid. Do not leave the unit running unattended. Do not tilt or turn over the unit. Do not unplug while the unit is operating. Do not unplug by pulling on the power cord. Do not use an extension cord or an adapter plug. Do not put objects on the unit. Do not climb or sit on the unit. Do not insert fingers or other objects into the air outlet.
2.2 SAFETY PRECAUTIONS ON SERVICING Please follow these warnings when to undertake the following when servicing a dehumidifier with R134a. ①Checks to the area Prior to beginning work on systems containing flammable refrigerants, safety checks are necessary to ensure that the risk of ignition is minimized. For repair to the refrigerating system, the following precautions shall be complied with prior to conducting work on the system.
⑧Checks to the refrigeration equipment Where electrical components are being changed, they shall be fit for the purpose and to the correct specification. At all times the manufacturer’s maintenance and service guidelines shall be followed. If in doubt consult the manufacturer’s technical department for assistance.
3 PRODUCT OVERVIEW FRONT 3.
4 INSTALLATION 4.1 LOCATION 1.Place the unit on a firm, level surface in an area with at least 30cm of free space around it to allow for proper air circulation. 2.Never install the unit where it could be subject to： Heat sources such as radiators, heat registers, stoves or other products that products that produce heat.
4.2 OPERATING THE DEVICE SAFELY Check the device after unpacking for any damages or scratches on it. Operate this unit in an ambient temperature from 41°Fto 95°F. Do not use in the outdoors. This dehumidifier is intended for indoor residential applications only. Do not operate in close proximity to walls, curtains, or other objects that may block inlet and outlet. Keep the air inlet and outlet free of obstacles. Adjusting the wind deflector in the upward direction prior to start up.
5 OPERATION CONTROL PANEL SETTINGS POWER In the standby state, press the power button to turn on, the operation indicator lights up and the default fan speed is high, and the default humidity is 50%. In the power-on state, press the power button to turn off, the running indicator light goes off and the compressor stops immediately, and then the fan shut down after 30 seconds delay. MODE Press the mode button to switch between Auto and Continuously dehumidify mode.
Sleep mode:In sleep mode , the target humidity is 60%, and after no operation for 10 seconds, except sleeping mode indicator light , power indicator light and child lock indicator light will dark, other the indicator lights and display screen will be off . When room humidity ≤ 57%RH，the compressor & fan will stop working . When room humidity ≥ 63%RH，the fan&compressor will start working .
DRAINAGE There are two ways of removal collected water produced by the unit. A. Manual draining: Empty water tank by manual. B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose. A.EMPTYING THE WATER TANK The water tank built in unit will fill up and shut the unit down once it is full. It will run again once you empty the water tank and installed properly. 1. When the tank is full, The machine will buzz for 5 times, and the “Water Tank Full” indicator light will light up.
2.Please make sure to clean the condensed water in the tank and put the tank in the original position. 3.If the water tank is dirty, please rinse it with clean water. Avoid using detergents, steel wire balls, chemical dust removers, diesel, benzene, diluents or other solvents. Otherwise, it can damage the tank and cause leaks. 4.Put the water tank in its original position. Otherwise, the indicator light will always be red and the machine cannot start working again. B.CONTINUOUS DRAINAGE 1.
14
6 MAINTENANCE Note: before cleaning and maintaining the machine, please be sure to turn off the machine and unplug the power to avoid electric shock. CLEANING THE AIR FILTER (every two weeks) Dust collects on the filter and restricts the airflow. The restricted airflow reduces the efficiency of the system and if it becomes blocked it can cause damage to the unit. The air filter requires regular cleaning. The air filter is removable for easy cleaning.
Picture Name Quantity Dehumidifier 1PCS Drain Hose 1PCS User Manual 1PCS 16
7 TROUBLE SHOOTING 1.FUNCTIONING TEMP 41°F Ambient Temp. 95°F When the ambient temp is lower or higher than the functioning temp, the dehumidifier stops. When 41°F Ambient temp. 60°F, the compressor automatically defrosts at intervals; during defrosting, the compressor stops and the fan keeps running. 2.
8 DECOMMISSIONING 8.1 STORAGE Long-term storage - If you will not be using the unit for an extended period of time (more than a few weeks) it is best to clean the unit and dry it out completely. Please store the unit per the following steps: 1.Press power button to switch off and unplug the unit. 2.Drain the remaining water from the unit. 3.Clean the filter and let the filter dry completely in a shaded area. 4.Collect the power cord at the water tank. 5.Re-install the filter at its position. 6.
9 SAFETY PRECAUTIONS :KHQ XVLQJ GR QRW SODFH WKH 'R QRW XVH WKLQ URGV RU KDUG :KHQ XVLQJ SOHDVH NHHS WKH GHKXPLGLILHU RQ VRIW XQHYHQ JURXQG REMHFWV WR LQVHUW LQWR WKH IXVHODJH WR GHKXPLGLILHU DZD\ IURP KHDW VRXUFHV WR DYRLG YLEUDWLRQ RU PRYHPHQW DYRLG PDOIXQFWLRQ RU GDQJHU VXFK DV KHDWHUV DQG HOHFWULF NHWWOHV WR VDYH HOHFWULFLW\ :KHQ XVLQJ SOHDVH FORVH WKH 'R QRW SODFH LWHPV EHIRUH DQG DIWHU WKH ,Q FDVH RI SRZHU IDLOXUH RU GRRUV DQG ZLQGRZV WR DFKLHYH WKH GHKXPLGLILHU ,
10 CUSTOMER SERVICE Lienuis offers a limited 1-year free warranty on this OL20-D068C dehumidifier,with original proof of purchase(typically you maybe only requested to offer the order number or other information to prove a genuine purchase,instead of an invoice) and where a defect has arisen, wholly or substantially, as a result of faulty manufacture,parts or workmanship during the warranty period.
