- RUNCO International OWNER'S OPERATING MANUAL 1080p Digital Light ProcessingTM Projector and Digital High Definition (DHDTM) Controller VX-44d, VX-55d

Table Of Contents
Runco VX-44d/-55d Owner’s Operating Manual 17
PRE
L
IMINAR
Y
3.1
Remote Control
To install batteries in the remote control,
press up on the battery cover retainer clip
and lift off the cover. Install the two AAA
batteries with the correct polarity and then
replace the cover.
Notes on Batteries Make sure that the battery polarities are correct when installing the batteries.
Do not mix an old battery with a new one or different types of batteries.
If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
Notes on Remote Control
Operation
Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the DHD Controller.
If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the DHD Controller, and repeat the operation.
3. Installation