- RUNCO International OWNER'S OPERATING MANUAL 1080p Digital Light ProcessingTM Projector and Digital High Definition (DHDTM) Controller VX-44d, VX-55d
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Projection Lens
- 3.5 Installing the Optional CineWide Lens Mount
- 3.6 Mounting the VX-44d/-55d
- 3.7 Connections to the VX-44d/-55d and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-44d/-55d
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Adjusting the Picture Orientation
- 3.10 Primary Lens Adjustments
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- 3.12 Calibrating Projector Input 2 (DVI)
- 3.13 Working With the Lamp
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
Controls and Functions
Runco VX-44d/-55d Owner’s Operating Manual 7
PRE
L
IMINAR
Y
1. RS232 IN
Connect the RS-232 output from the DHD Controller here, using the provided
RJ11-to-DB9 adapter and communication cable.
2. RS232 OUT
Not used.
3. RS422
Not used.
4. GPIO
Not used.
5. REMOTE
Wired input from an external remote control or infrared receiver.
6. ETHERNET
Reserved for future use.
7. INPUT 3 (Video) / INPUT 4 (S-Video)
Not used. Connect all video sources to the DHD Controller.
8. INPUT 2 (DVI)
HDCP-compliant digital video input. Connect the HDMI output from the DHD
Controller to this input.
9. INPUT 1 (RGBHV)
Not used. Connect all video sources to the DHD Controller.
10. INPUT 5 (Option 1)
Reserved for future use.
11. INPUT 6 (Option 2)
Reserved for future use.