Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
56 AC-F/G4x Series Installation and Programming Manual
If the PIN or user card presented is valid, the left LED stops
flashing and the controller is ready for you to enter the next
3-digit slot number (refer to Step 3
) for the slot to which
you
want to assign a code.
5.
Do one of the following:
Press # to move to the next available user slot number.
Enter another 3-digit user slot number.
If you do not wish to continue enrolling codes, press #
twice and the controller returns to Normal mode.
5.12.3.2 Enrolling Secondary Codes using the Code Search
Method
The code search method enables to quickly enroll a secondary
code for a user whose primary code is known and whose slot
number is unknown.
To enroll secondary codes using the Code Search method:
1.
Enter Programming mode.
2.
Press 7 to enter Menu 7.
The right LED turns orange.
3.
Enter 000 as the 3-digit user slot number.
The right LED flashes orange.
Orange
Orange
Green