Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Table of Contents
iv AC-F/G4x Series Installation and Programming Manual
4.3.4 From Bypass to Normal Mode .............................................................. 27
4.4 Auxiliary Input and Output ................................................................. 28
4.5 REX Function ............................................................................................. 28
4.6 Tamper Feature ....................................................................................... 29
4.7 Lockout Feature (Keypad/Card Tamper) ....................................... 29
4.8 BL-D40 External Sounder ..................................................................... 30
5.
Programming ........................................................... 31
5.1 Entering the Programming Mode .................................................... 33
5.2 Exiting the Programming Mode ....................................................... 33
5.3 Changing the Open Code ................................................................... 34
5.4 Changing the Auxiliary Code ............................................................. 36
5.5 Changing the Programming Code .................................................. 37
5.6 Changing the Normal/Secure Code ................................................ 38
5.7 Changing the Normal/Bypass Code ................................................ 38
5.8 Setting Fail Safe/Secure Operation ................................................. 40
5.9 Setting Auxiliary Modes ....................................................................... 41
5.9.1 Auxiliary Mode 0 ......................................................................................... 45
5.9.2 Auxiliary Mode 1 ......................................................................................... 45
5.9.3 Auxiliary Mode 2 ......................................................................................... 46
5.9.4 Auxiliary Mode 3 ......................................................................................... 46
5.9.5 Auxiliary Mode 4 ......................................................................................... 47