Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Operation
AC-F/G4x Series Installation and Programming Manual 25
A normal user only has a primary code and is granted access
only when the controller is in its Normal or Bypass mode.
Secure
A Secure user must have a Primary and Secondary code
assigned, and the two codes must not be the same. The
Secure user can gain access in any mode of operation. In
Normal mode, the Secure user must use the Primary code to
gain entry. In Secure mode, the Secure user must first enter
the Primary and then the Secondary code to gain entry.
Master
A Master user must have identical Primary and Secondary
codes assigned. The codes are entered with the same
proximity card or the same PIN. The Master user can gain
access during any mode of operation by entering the code
only once.