User's Guide
Table Of Contents
- Contents
- About this manual
- 1 Introduction
- The TankRadar Pro System
- Measurement Principle
- 2 Mechanical Installation
- Socket Requirements
- Free Space Requirements
- Dimensions
- Tools
- Mounting the Rod Antenna
- Mounting the Cone Antenna - PTFE sealing
- Mounting the Cone Antenna - Quartz Sealing
- Mounting the Cone Antenna - Process Seal
- Mounting the Parabolic Antenna
- 3 Electrical Installation
- Identication of Installed Options
- Junction Box
- External Connections
- Connecting to a TRL2 Bus Interface
- Connecting HART devices
- Connecting the Display Panel
- Cables
- Safety
- Power Supply
- Grounding
- System Overview
- Internal Connections
- 4 Pro Setup Software
- System Requirements
- Installing the Pro setup software
- Starting the Pro Setup Program
- Setting a Password
- Logging on to a password protected system.
- Setting measurement units
- Installing a Pro Transmitter
- Viewing Level Data
- Service
- 5 Using the Pro Display Panel
- Operation
- Viewing Level Data
- Installing a Pro Transmitter
- Service
- 6 Tank Distances
- Definitions
- Examples
- 7 Technical Information
- Technical Data
- Display Panel
- Analog Outputs
- 8 Troubleshooting
- Display Panel Error Messages
Saab TankRadar
®
ProPro Setup
4-2
Edition 2. Ref. No: 306010E
System Requirements
Processor: Pentium
Operating system: Windows95/NT 4.0
Memory: 16 MB
Hard disk space: 5 MB
Installing the Pro setup software
To install TankRadar Pro configuration software on your compu-
ter do the following:
1 Start Windows and make sure that no applications are running.
If you run Pro Setup under Windows 95, upgrade Windows 95 by
running the Dcom95.exe upgrade kit.
2 Insert the TankRadar Pro setup disk.
3 Select the Run command on the Start menu.
Browse to the diskett drive and select the setup file. Follow the
instructions.