Measurement Guide

8. Place the curtain onto the hanging rod (Curtain not
shown). Place one end of the hanging rod into one bracket.
9. Place the hanging rod onto the other hanging bracket.
(Curtain not shown). For additional support, install the third
bracket (56-108" & 108-168" only).
10. Tighten set screws on each bracket
to secure the rod.
5. Install the other bracket in the same way as steps 1-4.
Typically, the brackets should be the same distance from the
nearest parallel wall.
6. Adjust the bracket length by loosening the set screw
counter-clockwise and moving the hanger hook inward or
outward and then tighten in clockwise motion.
7. Adjust the other bracket to the same
length as 1st and hand-tighten screw.
1. Using the bracket as a template,
place it in the desired location. Mark
holes.
2. Drill 3/16" holes on pencil marks and
insert anchors until they are flush with
the ceiling.
3. Remove hook from the bracket by
loosening the set screw and then screw
the bracket to the ceiling.
4. Attach the hook to the bracket.
Attached bracket should look like this.
108-168" 4 tubes
108-168" 3 brackets
108-168" 6-anchors; 6-screws
Bracket Installation
36-56" 2 tubes
36-56" 2 brackets
36-56" 4-anchors; 4-screws
56-108" 2 tubes
56-108" 3 brackets
56-108" 6-anchors; 6 screws
I. Hanging Rod
II. Brackets
III. Wall mount anchors and screws
Hanging Rod Installation Instructions for CEILING MOUNTING
See other side for WALL MOUNTING instructions
Tools Required:
1. Drill with 3/16" drill bit
2. Phillips-head screwdriver
Parts List
Brackets must align.
1
3
2
1
2
3