Owners manual

[phone] • www.rollnlock.com
page 2
S TEP 1: A TTACH THE C ARGO M ANAGER T RACKS
A. Attach the Cargo Manager Tracks to the Roll-N-Lock Tracks (Diagram 1, next
page).
Note: The Roll-N-Lock unit must be installed fi rst. Check
Roll-N-Lock Tracks for straightness before attaching Cargo Manager Tracks.
Position the Cargo Manager Tracks with the specially machined end toward
the tailgate and the straight cut end approximately 1/2" from the Roll-N-Lock
Housing. When correctly positioned, the holes in both the Cargo Manager and
the Roll-N-Lock Tracks will align. Place an attaching screw (#10-24 x 1/2" truss
head screws) in the fi rst available hole at each end of the Track and equally
space the two remaining screws in the holes available.
H ARDWARE & C OMPONENTS I NCLUDED
x 9 pieces
#10-24 X 1/2" Truss Head
Screw, for attachment of
Tram Plate assembly and
attachment of Tracks to RNL
Tracks
x 8 pieces
Threaded Tangs (cargo nuts),
for attachment of Tracks to
RNL Tracks
x 1 piece
#10-24 Hex Nut, used for
Tram Plate assembly
x 1 piece
Delrin wheel, for Tram Plate
assembly
x 1 piece
5/16" x 3/8" SS Shoulder
Bolt, for Tram Plate assembly
x 1 piece
1/4-20 Lock Nut, used for
Tram Plate assembly
x 1 piece
#10 Lock Washer, used for
Tram Plate assembly
x 2 pieces
Tork Head Screws, used for
Tram Plate assembly
x 1 pieces
#6 x 3/8" Truss Head Screw,
to secure Driver Side Stem
x 1 piece
Allen key, used for Tram Plate
assembly
x 1 piece
Torx key, used for Tram Plate
assembly
x 2 pieces
Star , for Tram Plate
assembly
x 2 pieces
(Driver / Passenger side
Stem, used for Tram Plate
assembly