Operation Manual

19
2. INPUTS - OUTPUTS - CONTROLS
19
1. RCA inputs (CH1/2, CH3/4, CH5/6, left and right
channels). Line inputs for connection with RCA line-out’s
of the head-unit
2. Input gain control, LEVEL adjustment for channels
CH1/2. Used to match the RCA line output voltage of the
head-unit to the amplifier input section
3. Operation mode selector, slide switch to select
highpass or fullrange operation of the active crossover for
channels CH1/2
4. Highpass crossover frequency control, to adjust the
cut-in frequency of the channels CH1/2
5. Input gain control, LEVEL adjustment for channels
CH3/4. Used to match the RCA line output voltage of the
head-unit to the amplifier input section
6. Operation mode selector, slide switch to select
highpass, bandpass or fullrange operation of the active
crossover for channels CH3/4
7. Highpass crossover frequency control, to adjust the
cut-in frequency of the channels CH3/4
8. Lowpass crossover frequency control, to adjust the
cut-off frequency of the channels CH3/4
9. Input gain control, LEVEL adjustment for channels
CH5/6. Used to match the RCA line output voltage of the
head-unit to the amplifier input section
10. Operation mode selector, slide switch to select
highpass, bandpass or fullrange operation of the active
crossover for channels CH5/6
11. Highpass crossover frequency control, to adjust the
cut-in frequency of the channels CH5/6
12. Lowpass crossover frequency control, to adjust the
cut-off frequency of the channels CH5/6
13. Slide switch to activate/deactivate the phase-shift
control feature of channels 5/6
14. Phase-shift control, to alter the acoustical phase of the
out-put signal from 0 - 180°
15. Operation LED, is lit blue when power is on
16. Protection LED, is lit red when the amplifier is in
protection mode because of malfunction, overheating or
short-cut on speaker cable leads
17. Terminal block for the speaker wire connection
18. Fuses
19. "+12V" for connection to the positive terminal of car
battery
20. "GND" for connection to chassis ground or negative
terminal of car battery
21. "REM" for the automatic (remote) turn-on / turn-off of the
power amplifier from the head-unit's remote or antenna
control lead
Ro 6-CH Manual_D+E.indd 19 27.02.2006 18:15:45 Uhr