Manual

64
Step 6
Step 7
Turn the PARAMETER SELECT knob one step clockwise to display the Upper Limit
parameter (for PARA 1).
Step 8
Use the PARAMETER ADJUST knob to choose the highest value that the parameter
is not allowed to exceed when the toe of the expression pedal is down.
Step 9
Turn the PARAMETER SELECT knob one step clockwise to access the Lower Limit
parameter (for PARA 1).
Use the PARAMETER ADJUST knob to select the lowest value which the parameter
is not to fall below through when the heel of the expression pedal is down.
NOTE: The UTOPIA G200 allows you to select an upper and lower value limit which the parameter
cannot exceed. For example, if a parameter has a value range from 0 to 127, yet you would like the
range of the parameter to vary from only 50 to 127, you may set a lower limit of 50 and an upper limit
of 127 via the Upper (ULIM) and Lower Limit (LLIM) parameters. When a parameter is stored in the
Pedal Controller function (Step 7), the maximum parameter value is automatically stored as the upper
limit (expression pedal toe down), while the minimum value is stored as the lower limit (expression
pedal heel down).
p e d a l c o n t r o l e r s
u l i m c 1 1 0 0
8. Pedal Controllers......continued..........
p e d a l c o n t r o l e r s
u l i m c 1 1 2 7
p e d a l c o n t r o l e r s
u l i m c 1 0
p e d a l c o n t r o l e r s
u l i m c 1 5 0
NOTE: Parameters available to be assigned may vary depending on what MODULATION effect you have selected for that
particular preset.
NOTE: Because character space on the display is limited, you may not see the entire name of a parameter. For example,
to choose FLANGER LEVEL 1 or FLANGER PAN 1 (or any of the Flanger's parameters), select "LEVEL 1" or "PAN 1"
parameter that immediately follows the "FLANGER" parameter when turning the PARAMETER ADJUST knob clockwise.
This is true for some other parameters as well.