Operating instructions

71
( 1 ) CNTNUM
7
PARM
PITCH1
UPLIM
0
LOWLIM
0
( 1 ) CNTNUM
7
PARM
PITCH1
UPLIM
+300
LOWLIM
0
———————————————————————————————————————————————————
3 Use the control labeled “MID” to select the Prophesy parameter that is
to be controlled by the MIDI controlling device. The MID control
scrolls through all available Prophesy adjustable parameters.
———————————————————————————————————————————————————
4 Use the control labeled “TREBLE” to select the highest parameter
value that the parameter is not to exceed through MIDI control
changes.
———————————————————————————————————————————————————
5 Use the control labeled “PRESENCE” to select the lowest parameter
value which the parameter will not fall below through MIDI control
changes.
———————————————————————————————————————————————————
6 Once steps 1-5 have been completed for controller page ( 1 ), store
the new settings as described under the subheading entitled “Storing
modified presets” earlier in this section so that they will be in effect
each time the current preset is recalled.
You may now use the PAGE control to access the next controller page
and repeat Steps 2-6 to configure another Prophesy parameter to be
controlled by a MIDI controller, if desired. Up to 8 controllers can be
configured per preset.
( 1 ) CNTNUM
7
PARM
PITCH1
UPLIM
+300
LOWLIM
-200
G
Reversing upper
and lower limit
settings
The upper and lower limit
parameter values can be
reversed, so that the upper
limit parameter actually
holds a lower value than the
lower limit value.
This effectively reverses the
operation of the MIDI
controller, such that the toe
position of a footpedal
would produce the lowest
value, and the heel position
would provide the highest
value.