ROC006P V-Tail Glider Manual
Low voltage cut off (LVC)
page5
Charging the Flight Battery
Protection Function
1. Reverse connection protection of input
2. Reverse connection protection of output
3. Short circuit protection of output
4. Over voltage protection of output
Troubleshooting
1. Power LED does not shine – Adapter isn’t connected correctly. Please check the polarity and
reconnect adapter.
2. Charging abruptly stops and tries to restart constantly during charging – Output power of
the adapter is not sufficient, please replace the adapter.
3. Charge LED does not shine – Reconnect the battery pack; Check the voltage of batteries.
4. Charge LED rapidly flickers – Battery is bad or charging function is abnormal. Replace battery
or contact technical support.
WhenaLi-Poisdischarged below 3V per cell, it will not hold a charge. The ESC protects
the flight battery from over-discharge using Low Voltage Cutoff. Before the battery charge
decreases too much, LVC removes power from motor in two ways: (1) Reduces power - ESC
reduces motor power (recommended), (2) Hard cutoff - ESC instantly cuts motor power when
the pre-set Low Voltage Protection Threshold value is reached. These settings can be
changed using the ESC programing guide (available on-line).
For More Info Vist: www.motionrc.com